The AP properties dialog box displays information about the AP including name, venue, serial number MAC address, IP address, timing source, firmware version, SAS, and so on.
To view detailed information about an AP from the
Access Point overview page, go to the
AP Properties section, and then click
More.
The page that loads displays the following information:
Name: The name of the AP.
Venue: The name of the venue to which the AP is deployed.
Description: The description currently assigned to the AP.
S/N: The serial number of AP.
MAC Address: The MAC address of the AP.
IP Address: The IP address that is currently assigned to the AP.
Model: The AP model.
Band: The frequency band, which is a specific range of frequencies in the radio frequency (RF) spectrum, ranging from low frequencies to high frequencies. Each
band has a defined upper and lower frequency limit.
FW Version: The firmware release that is currently installed on the AP.
NTP Sync Status:: Status of NTP synchronization.
NTP Local Time: The current date and time.
NTP Server IP:The host name or IP address.
Radio Parameters
ECGI: ECGI is the Identifier which is used to identify cells globally. The ECGI is constructed from the MCC (Mobile Country Code), MNC (Mobile Network Code) and the ECI (E-UTRAN Cell Identifier).
Physical Cell ID: The identification of a cell at the physical layer.
Networking Parameters
EPC (S1) Connection status: The S1 connection status. For example, Connected
Timing Role: The timing role: master, slave, or independent. For example, Independent (internal clock).
Timing source: The timing source. For example, Internal Clock
Timing Sync Status: The time synchronization status. For example, Lock.
VLANS
Management VLAN: The number of management VLAN.
Data VLAN: The number of data VLANs.
Timing VLAN: The number of timing VLANs.
SAS Information: The information pertaining to the spectrum allocation servers, which automates the process of assigning spectrum.
CBSD ID : The CBSD Identifier.
Latitude: The latitude of the location.
Longitude: The longitude of the location
Height (AGL): The height above the ground level.
Status: The status of the AP.
Center Frequency: The center frequency.
Bandwidth: The network bandwidth.
Granted Max EIRP: The maximum EIRP granted.
EIRP In-use: The EIRP in use.
Channel: The channel number.
When LTE AP operates in Carrier Aggregation (CA) mode and obtain appropriate grants to transmit from SAS, Cell 2 and Cell 2 details are displayed:
AP Properties
The CPI data for Q950 is displayed as follows.
Antenna Beamwidth: The Beamwidth of the antenna.
Antenna Azimuth: The azimuth of the antenna.
Antenna Down Tilt: The downtilt angle of the antenna.
