RUCKUS ICX Switch Port LEDs

RUCKUS ICX switches have LED indicators on their ports. The behavior of these LEDs can provide valuable information about the status of the ports and the devices connected to them.

Feature Overview

The RUCKUS One web UI allows you to configure the LEDs on standalone RUCKUS ICX switches or switch stacks to blink, assisting in device identification.
  • Duration: Refers to the length of time the LED will blink, which can be set from a minimum of 15 seconds to a maximum of 120 seconds.
  • Unit: Only applicable to a switch stack, where it indicates the unit ID of the whole stack or the standalone switch in the stack.
A notification is displayed to confirm the successful execution of the operation. If there is no response for 120 seconds, a failure notification is displayed.

Requirements

This feature requires the RUCKUS ICX switch or stack to be managed by RUCKUS One.

Considerations

This feature has no special considerations or limitations pertaining to feature enablement or usage.

Best Practices

This feature has no special recommendations for feature enablement or usage.

Prerequisites

The RUCKUS ICX switch or stack must be added to the RUCKUS One account. For more information see Adding a Switch and Adding a Stack.The selected ICX switch or stack must have an Operational status for RUCKUS One to initiate LED blinking remotely.